Euphonix R-1 Remote Manual do Utilizador descarregar pdf (Página 10)

Phantom Power: 48V Jumper Settings

Phantom power is enabled by fitting the link to short pins 1 and 2; If not required (eg. A

dynamic mic is being used) then it should be set to short pins 2 and 3. Pin 1 position can be

ascertained by looking at the solder side, where the square pad is.

Note that the standard talk back mic on the console (wired to T1) is a condenser type which

needs the phantom to be enabled. The mapping of the jumpers is as follows:

Upper board:

J1: Talkback 1 (T1)

J2: Talkback 2 (T2)

J3: Listen 1 (L1)

Lower board:

J1: Listen 2 (L2)

J2: Listen 3 (L3)

J3: Listen 4 (L4)

Environmental Requirements

5 to 35 degrees Centigrade.

Power Requirements

90- 240 VAC, 50/60Hz.

Power Consumption

70W

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 24 25

Sem comentários

Euphonix R-1 Remote Manual do Utilizador Página 10