Euphonix System 5 Manual do Utilizador descarregar pdf (Página 9)

Euphonix System 5 Post and Film Setup Guide

Connect the TFT backlight cable to the connector on the upper board of the film panel.

Joystick Panel Installation

Connect the 5-V power cables (red) from the Joystick to the header block on the bottom

of the module. Be sure to maintain correct polarity (red/white stripe is negative). See

the photo in Film Panel Installation. Connect the serial cables from the 9-pin connectors

on the rear panel of the CM403 to the headers on the joystick PCBs. Attach two serial

cables between the external CM403 9-pin joystick ports and the adjacent CM408 9-pin

serial ports.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Sem comentários

Euphonix System 5 Manual do Utilizador Página 9